2k Acrylic Clear

  • High quality acrylic polyol based topcoat finish and forms a two component product with a suitable curing agent
  • The product is designed to have high pigmentation or a clear top coat with ability of accepting metallic pigments
  • Good film built up with good flow properties
  • The post cured film has good mechanical properties along with flexibility and toughness
  • Being an acrylic product it is especially known for non yellowing properties and good weathering resistance
  • It is generally recommended as a top coat for the automobile and other auto refinishes

Designed Use:

  1. It is recommended as a protective top coat with UV Radiation for topcoats with suitable primers for the automobile refinishes and body applications
  2. It can be used as a topcoat for other metal based coatings


  1. Available as per requirement


  1. The theoretical coverage of VITON 2K ACRYLIC CLEAR be approximately 6-7  M²/ liter per coat at a Dry film thickness of 25 – 30 µ per coat


Surface Preparation:

  1. Avoid humid conditions >95% and also dew point of <3% for application)
  2. The expected life span is directly related to the surface cleanliness and proper application.
    1. It is therefore mandatory to remove the grease, oil, and wax by solvent cleaning
  3. Apply VITON 2K ACRYLIC PAINT before applying VITON 2K ACRYLIC CLEAR top coat for thorough binding properties
  4. Stir well each component with convenient mixing equipment for uniformity to ensure good mixing of all the components.
    1. In case of metallic auto finishes see that the metallic pigments do not have any agglomerates to result in a poor finish

*Not suitable for perpetual wet conditions. The product will not cure below 10°c, dry heat resistance is 120°c

Method of application:

  1. Conventional Spray: It is the most recommended method of application Use standard equipment and a pressure of 2.8-3.0 kg/ cm2 (40-45 psi)
  2. Brush or Roller: This method may be adopted for substrates with difficult shapes or touchup; however care must be taken not to exceed the recommended film thickness and ensure that an even film is applied
  3. Air less spray: For larger areas it is the best recommended method of application but great care must be taken to ensure the recommended film thickness are not exceeded. Use a tip with a wide fan width. Tip Size : 0.22 – 0.30 mm (0.009 – 0.011 in) Pressure: 90 – 130 Kg/cm2 (1300-1800 psi)

Caution:*Not suitable for perpetual wet conditions. The product is extremely sensitive to moisture; dry heat resistance is 70°c. 

Thinning recommendation:

  1. VITON 2K ACRYLIC (SLOW) THINNER and to the extent of maximum of 10-15% of the paint by volume.
  2. Stir well with a convenient mixing equipment for uniformity to ensure good mixing of all the components


Pack Sizes:

  1. Available in metal tins in 1 and 4 liter packs