Home TORPEDO MARINE ENAMEL

TORPEDO MARINE ENAMEL

Torpedo Marine Enamel

  • Compounded from Quick Dry Synthetic Alkyd system with Titanium Dioxide and other inert pigments and tough extenders. This product is quick drying, with good build up and has good weathering properties.

Designed use

Designed Use:

  1. It is recommended as the right system for coating of Iron, Steel, Zinc, Aluminum, and masonry with suitable undercoats as per recommendation over a wide range of temperature.

Availability:

  1. Standard shades are available as per customer requirement.

Coverage:

  1. The theoretical coverage of TORPEDO MARINE ENAMEL would be approximately 8 – 10 M²/liter at a Dry film thickness of 30 – 40 µ

*Due consideration must be given to the evenness of the surface and the nature of the substrate.

Surface preparation

Surface preparation:

  1. Avoid humid conditions >95% and also dew point of <3% for application
  2. The expected life span is directly related to the surface cleanliness and proper application, it is therefore mandatory to remove the grease, oil and wax by solvent cleaning
    1. Any rust or salts can be removed by dry brush, chipping, needle gun or spot blast
    2. Soluble salts must be washed and dried before the painting job
    3. Possible weld spatters/spots should be trimmed, rounded and surfaced before the painting job
  3. Stir well with a convenient mixing equipment for uniformity to ensure good mixing of all the components
  4. Apply one or two coats of TORPEDO MARINE UNDERCOAT as required as per surface profile, for thorough binding properties for top coat
  5. Finally apply one or two coats of TORPEDO MARINE ENAMEL as required

*Not suitable for immersed conditions & cannot be coated with 2K, Vinyl & aromatic thinned alkyd systems.

Method of application

Method of application:

  1. By roller/brush and if large areas are to be painted one can use suitable spray application.
  2. To keep the brush/roller and spray equipment in good condition for use, clean the same in ROBBIALAC G.P THINNER and dry them immediately after application.

Thinning recommendation:

  1. ROBBIALAC G.P THINNER and to the extent of maximum of 5-10% of the paint by volume.
  2. Stir well with a convenient mixing equipment for uniformity to ensure good mixing of all the components.

Pack Sizes:

  1. Available in metal tins of 4L packs
× Lets Chat