ROBBIALAC SUPER RED OXIDE PRIMER

General purpose synthetic alkyd primer containing rust inhibitive and protective pigments for the protection of steel and other metal substrates
It has good drying properties and offers a good anchorage for the subsequent coats with adequate adhesion
It gives a fairly smooth matt finish

Designed Use:

Availability:

Coverage:

The theoretical coverage of ROBBIALAC SHIELD RED OXIDE PRIMER would be approximately 6-8 M²/liter at a Dry film thickness of 30 µ

*Due consideration must be given to the evenness of the surface and the nature of the substrate.

Surface preparation:

Avoid humid conditions >95% and also dew point of <3% for application
The expected life span is directly related to the surface cleanliness.
1. It is therefore mandatory to remove the grease, oil, wax by solvent cleaning
Any rust or salts can be removed by dry brush, chipping, needle gun or spot blast Soluble salts must be washed and dried before the painting job
Possible weld spatters/spots should be trimmed, rounded and surfaced before the painting job
Stir well with a convenient mixing equipment for uniformity to ensure good mixing of all the components
One or two coats of ROBBIALAC SHIELD RED OXIDE PRIMER can be applied as required

*Not suitable for immersed conditions & cannot be coated with 2K, Vinyl & aromatic thinned alkyd systems.

Method of application:

By roller/brush and if large areas are to be painted one can use suitable spray application.
To keep the brush/roller and spray equipment in good condition for use, clean the same in ROBBIALAC G.P THINNER and dry them immediately after application.

Thinning recommendation:

ROBBIALAC G.P THINNER and to the extent of maximum of 10% of the paint
Stir well with a convenient mixing equipment for uniformity to ensure good mixing of all the components.

Pack Sizes: